Installation Instructions Istruzioni per l`installazione SCSI
by user
Comments
Transcript
Installation Instructions Istruzioni per l`installazione SCSI
USI C LM GEN ERA WK6 - WK8 SK760 - SK880 EQUINOX SCSI Interface Kit Installation Instructions Istruzioni per l’installazione ENGLISH/ITALIANO code: 271238 CAUTION Read these notes before proceeding These servicing instructions are for use by qualified personnel only. To reduce the risk of electric shock and device malfunction, do not perform any user-servicing but refer all servicing to the nearest Service Center Authorized by GENERALMUSIC. Any servicing performed by unqualified service personnel will forfeit all GUARANTEE rights and will exonerate GENERALMUSIC from all all liabilities for damage to property or persons resulting from device malfunction. ATTENZIONE Leggi queste note prima di procedere Le seguenti istruzioni di servizio sono ad esclusivo uso di personale qualificato. Per evitare il rischio di scosse elettriche e malfunzionamenti dell’ apparecchio, non tentate di effettuare personalmente queste operazioni, rivolgetevi al più vicino Centro di Assistenza Autorizzato GENERALMUSIC. Ogni intervento effettuato da personale non qualificato farà decadere i diritti di GARANZIA ed esonererà GENERALMUSIC da ogni responsabilità su eventuali danni a persone o cose conseguenti dal suo malfunzionamento. ATTENTION Observe precautions when handling electrostatic sensitive devices. ATTENZIONE Maneggiare con cura i dispositivi elettronici sensibili alle cariche elettrostatiche. IMPORTANT: Part below to be filled in by the service center. IMPORTANTE: Fate compilare al servizio di assistenza la parte sottostante. Stamp of Service Center Authorized by Generalmusic Timbro Centro Assistenza Autorizzato da Generalmusic Installation Date. Data di installazione. Device serial number. Numero di serie apparecchio. Optional accessory installed. Accessorio opzionale installato. WK6 and WK8 Opening / Apertura Model - Modello ! ! Instructions / Istruzioni ENGLISH Disconnect the instrument from the mains. Carefully turn the instrument over and unscrew the screww marked by the arrows. Hold the chassis (top and bottom) tightly and turn the instrument the right way up. Grasp the extreme top ends of the lid and lift it off by following the sequence of illustrations A, B and C. ITALIANO Sconnetti lo strumento dalla presa di corrente. Rovesciare con attenzione lo strument e rimuovere le viti indicate dalle frecce. Trattenendo saldamente le parte superiore e inferiore dello strumento raddrizzarlo, afferrare le estremitˇ del coperchio e sollevarlo seguendo le istruzioni A, B e C. Front / Davanti Rear / Dietro (A) Lift up Sollevare (B) Pull towards you to clear the keyboard. Tiralo verso te per liberarlo dalla tastiera. (C) Raise the lid, taking care not to disconnect the cables. Sollevare il coperchio, facendo attenzione a non scollegare i cavi. ! Mounting Instructions M-3 Opening / Apertura SK760 and SK880 ! Instructions / Istruzioni Model - Modello ENGLISH Disconnect the instrument from the mains. Carefully turn the instrument over and unscrew the screws marked by the arrows. Hold the chassis (top & Bottom) tightly and turn the instrument the right way up, lift off the top chassis as shown in the figure with care without forcing or disconnecting the cables. ! ITALIANO Sconnettere lo strumento dalla presa di corrente. Rovesciare con attenzione lo strumento e rimuovere le viti indicate dalle frecce. Trattenendo saldamente le parti superiore e inferiore raddrizzare lo strumento, rimuovere la parte superiore come indicato in figura, attenzione a non forzare o scollegare i cavi. SK88/880 Front / Davanti Rear / Dietro SK76/760 Front / Davanti Rear / Dietro a) Lift up. Sollevare. a) Be careful do not disconnect the cables. Attenzione a non sconnettere i cavi. ! ! M-4 Mounting Instructions EQUINOX ! ! Opening / Apertura Model - Modello Instructions / Istruzioni ENGLISH Disconnect the instrument from the mains. Carefully turn the instrument over and unscrew the screws marked by the arrows. Hold the chassis (top & Bottom) tightly and turn the instrument the right way up, lift off the top chassis as shown in the figure with care without forcing or disconnecting the cables. ITALIANO Sconnettere lo strumento dalla presa di corrente. Rovesciare con attenzione lo strumento e rimuovere le viti indicate dalle frecce. Trattenendo saldamente le parti superiore e inferiore raddrizzare lo strumento, rimuovere la parte superiore come indicato in figura, attenzione a non forzare o scollegare i cavi. 61 notes Front / Davanti Rear / Dietro 76 notes Front / Davanti Rear / Dietro a) Be careful do not disconnect the cables. Attenzione a non sconnettere i cavi. a) Lift up. Sollevare. ! ! Mounting Instructions M-5 Mounting/Montaggio EQUINOX - WK6/8 - SK760/880 Model - Modello Instructions / Istruzioni 970330 - SCSI interface kit 970330 - Kit interfaccia SCSI ENGLISH ITALIANO Part List (supplied): Lista parti (fornite): A) SCSI interface board (761177) (171466) B) Support for WK keyboard C) Support for SK and Equinox keyb. (171453) D) 4 screws (M3x6) (120029) E) 4 grower washers 3mm (120521) F) 1 screw 2.9x6.5mm (120255) G) 34 contacts x 25cm flat cable (841183) H) 34 contacts x 5 cm flat cable (841152) I ) 22 cm plaited cable (841186) L) 7.5 cm plaited cable (841185) A) Scheda interfaccia SCSI B) Supporto per tastiera WK C) Supporto per tast. SK e Equinox D) 4 viti (M3x6) E) 4 rondelle grower 3mm F) 1 vite 2.9x6.5mm G) Cavo piatto 34 contatti 25cm H) Cavo piatto 34 contatti 5cm I ) Cavo intrecciato 22cm L) Cavo intrecciato 7.5cm Tools (not supplied): Utensili (non forniti): N) Phillips screwdriver O) 5.5mm vertical nut wrench N) Cacciavite a croce O) Chiave inglese verticale 5.5mm see FIG.1 (761177) (171466) (171453) (120029) (120521) (120255) (841183) (841152) (841186) (841185) vedi FIG.1 Instructions: Istruzioni: - To install the kit into EQUINOX, SK760 or SK880 keyboards, follow the instructions on page 9-10. - To install the kit into WK6 or WK8 keyboards follow the instructions on page 7-8. - Per montare il kit sulla tastiera EQUINOX o SK760 o SK880 segui le istruzioni a pagina 9-10. - Per montare il kit sulla tastiera WK6 e WK8 segui le istruzioni a pagina 7-8. Fig.1 C M E N D Mounting Instructions M-6 F B O I G A L H WK6 - WK8 Model/Modello ENGLISH - Anchor the SCSI board (A) to the support (B) using the screws (D) and washers (E) as show on fig.2. Mounting/Montaggio Instructions/Istruzioni ITALIANO - Assemblare la scheda SCSI (A) al supporto (B) usando le viti (D) e le loro rondelle (E) come da fig.2. Fig.2 D E - Locate the SCSI slot cover and remove it by unscrewing the 3 screws that fix it to the chassis. - Connect the flat cable (H) and the plaited cable (L) to CN16 connector and S1 faston on CPU board (fig.3). Fig.3 - Localizzare il coperchio del vano SCSI e rimuoverlo svitando le 3 viti che lo fissano al fondo. - Connettere il cavo piatto (H) e il cavo intrecciato (L) al connettore CN16 e al faston S1 sulla scheda CPU vedi figura 3. L H Mounting Instructions M-7 Mounting/Montaggio WK6 - WK8 Model - Modello Instructions / Istruzioni ENGLISH ITALIANO - Connect the other ends of the cables (H) and (L) to - Connettere l'altro capo dei cavi (H) e (L) alla the SCSI board and to the support as show in figure 4. scheda SCSI e al supporto come da figura 4. Fig.4 A + B L H - Fix the SCSI kit to its location using the 3 previously removed screws and the screw (F) as shown in fig.5. Fig.5 Fissare il kit SCSI nella suo posto tramite le 3 viti rimosse precedentemente e con la vite (F) come da figura 5. F - Close the instrument and check for correct SCSI operation as described in the owner’s manual. Mounting Instructions M-8 - Chiudere lo strumento e controllare il corretto funziomento della SCSI come descritto nel manuale d’uso in dotazione con lo strmuento. EQUINOX - SK760 - SK880 Model/Modello ENGLISH - Anchor the SCSI board (A) to the support (C) using the screws (D) and washers (E) as show on fig.2. Mounting/Montaggio Instructions/Istruzioni ITALIANO - Assemblare la scheda SCSI (A) al supporto (C) usando le viti (D) e le loro rondelle (E) come da fig.2. Fig.2 D E - Locate the SCSI slot cover on the cover right side and - Localizzare il coperchio del vano SCSI sulla destra remove it unscrewing the 2 nuts as show in fig.3. del coperchio e rimuoverlo svitando i 2 dadi come Note: the photos show the EQUINOX model, the SK da figura 3. Nota: le foto rappresentano il modello EQUINOX, models are similar for the parts concerned. i modelli SK sono simili per le parti in oggetto. Fig.3 Mounting Instructions M-9 Mounting/Montaggio EQUINOX - SK760 - SK880 Model - Modello Instructions / Istruzioni ENGLISH ITALIANO - Fix the SCSI kit on its location using the two previously - Fissare il kit SCSI al suo posto usando i due dadi removed nuts. rimossi precedentemente. - Connect the plaited cable (I) to S1 faston on CPU bo- - Connettere il cavo intrecciato (I) al faston S1 sulla ard and the other end to S1 faston on SCSI board. scheda CPU e l'altro capo al faston S1 sulla scheda as show in figure 4. SCSI come da figura 4. Fig.4 A + C I - Connect the flat cable (G) to CN16 connector on CPU - Collegare il cavo piatto (G) al connettore CN16 board and the other end to CN1 on SCSI board as sulla scheda CPU e l'altro capo al connettore CN1 sulla scheda SCSI come da figura 5. show in figure 5. Fig.5 G - Close the instrument and check the SCSI correct operations as described on the supplied manual. Mounting Instructions M-10 - Chiudere lo strumento e controllare il corretto funzionamento della SCSI come descritto sull' accluso manuale.